Extractor Cone Stock (2/3/2006)

304L stainless steel rod will be used to fabricate extractor cones.

Bar stock (4/14/2006)

Faced off on lathe. 1.5" OD by 12" long 304L SS alloy.

Bar stock (4/14/2006)

Close up.

Extractor Cone (4/14/2006)

Turned down using taper adjustment at 60 degrees. Base of cone is 0.95"

Extractor Cone (4/14/2006)

Diameter reduced to 1.37" for proper clearances in 1.5" OD tube.

Extractor Cone (4/14/2006)

Notched with parting bit.

Band saw (4/14/2006)

Band saw (4/14/2006)

Band saw is used to separate the cone from the bar stock.

Extractor Cone (4/14/2006)

Cut off with Band saw

Extractor Cone (4/14/2006)

Bell area faced off on lathe.

Extractor Cone (4/14/2006)

Side view.

Center Drill (4/14/2006)

1/8" hole is center drilled as a pilot.

Extractor Cone Bell (4/14/2006)

Bell is drilled at 60 degrees with a 7/8" diameter.

Extractor Cone Aperture (4/14/2006)

3/32" Aperture is drilled from the vertices of the bell and cone.

Extractor Cone (4/14/2006)

Extractor Cone (4/14/2006)